[size="3"][color="Blue"][b]i had a bad front cv axle boot
so so i put an axle in the drivers side (already had a new
one on pass. side) that didnt help either. i swapped the
whole set of wheels for another set of stockers i had to no
avail. i put it up on the rack and pry'd on all 4 ball
joints and tie rod ends and got no movement and nothing
looked bent so i put a steering damper on it and still
shakes between 40-45 speeding up or slowing down when it
gets in that range it shakes. today it dro
hey man if you did all of that i would check your U-joints
on your drive shaft I bet some of the needle berings in it
slipped causeing an un balanced drive shaftYou Break A Dana 30 You Put A Dana 44 In It, You Break A Dana 44 You Put A Dana 60 In It, You Break A Dana 60. Give Up!!
Mine started at 65 or 70 as well I put on new shocks,
stering dampner, greased up my cv joints, got new tires, and
had them all ligned up and balanced and then i replaced all
four rotors cause when i braked it started shaking. It
hasn't shaken since.W. Steinheimer 1995 zj 3" teraflex suspension lift kit 31x10.5 BFG A/T
Check your drop track bar bracket make sure it is tight
cause when i was going anywhere from 35 to 55 and then i
would start to shake and it striped the nuts threads on the
bracket cause there not grade 8 nuts.
Jeep, Wrangler, Cherokee and Grand Cherokee are copyrighted and trademarked to the Jeep/Chrysler Corporation
JeepForum is not in any way associated with Jeep or the Chrysler Corp.
